Spiral chute process picture

Spiral chute process image, spiral chute process image 1, describes gravity beneficiation, which is widely used in metal and non-metallic ore beneficiation due to its low environmental pollution and low cost. The spiral concentrator is one of the gravity separation equipment, with a structural characteristic that the cross-section presents a cubic parabolic state, suitable for processing finer particle sizes of -0.2MM. In the sorting process, there is no need to add flushing water, and fine, medium, and tailings are selected in sections at the tail of the tank. 2、 Operating principle. The spiral mineral separator is freely placed on the cross (or tripod) of the support table. The same slurry is slowly fed onto the spiral groove surface of the feeding groove installed on the rotating groove head for sorting. The tail end is equipped with a valve block type product cutting groove, allowing the sorting equipment to be divided into three (or four) types according to grade along the radial direction. Change the acquisition width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that distinguishes and aggregates the selected multi-directional mineral flow. The transverse surface of the fiberglass chute has a slope change that is extremely suitable for the selection of fine-grained materials. Spiral chute process picture 3. Characteristic 1. The sorting process is stable and easy to control. 2. The feed density allows a wide range of differences. 3. The ultra-high enrichment ratio and high recovery rate. 4. The area occupied is small and the water consumption is small. 5. The structure is simple, without power. 6. The processing capacity is large. 7. Installation is simple and easy to operate. 8. The investment is low, and the effect is quick. The spiral chute process image is . 4、 The fiberglass spiral chute is composed of six parts: a feeding distributor, a feeding chute, a spiral groove, an equipment acquisition groove, a product gathering hopper, and a bracket (including a cross or triangular frame) for this groove. The rotating groove connected by the rotating disc is the main accessory. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and is bolted together. The spiral groove has a pre made durable wear-resistant layer on the selected surface. She has the advantages of lightweight, strong, and durable consumables. The head of the rotating groove is equipped with a multi tube ore feeding homogenizer to divide the ore dressing evenly, and the control is not cumbersome. The mineral sorting machine is freely stacked on a cross (or tripod) on a supporting table. The evenly divided slurry is slowly fed to the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and sorting is carried out. The tail end of the spiral groove is installed in a valve block type new product selection groove, and the selected new products are divided into three (or four) types of new equipment along the radial direction according to grade. Change the cutting width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the diverse mineral flows obtained to converge and export differently. The transverse plane and slope of the curve of the spiral chute are very suitable for the selection of small particle materials. 5、 The application scope of the spiral concentrator is to process 0.6-0.03mm and vein ores and minerals, but high mud content is unfavorable for beneficiation. At present, it has been widely used for processing iron ore, tungsten, tin ore, niobium tantalum ore, coastal or riverside placer and gold ore, and so on. Spiral chute process image Spiral chute process image