Spiral chute CAD drawings

Spiral Chute CAD Drawing 1. Overview. Chute sorting includes the process of inclined flow sorting. The slurry is fed to a inclined groove or inclined surface with a certain inclination. With the assistance of flowing water, the ore particles are loose and layered. The upper layer of light mineral materials are quickly discharged to the outside of the groove, while the lower layer of minerals with a larger proportion are stagnant inside the groove or slowly discharged from the lower part. After the difference is connected, the selected ore and tailings can be obtained. Spiral chutes are mining and beneficiation machinery, making them ideal for sand mining and beneficiation in coastal areas, rivers, beaches, and streams. The product also has the characteristics of suitable structure, simple installation, small footprint, easy operation, stable beneficiation, clear beneficiation, strong processing capacity, high efficiency beneficiation concentration ratio, high recovery rate, and stable operation. It has the advantages of small weight, moisture prevention, rust prevention, durability and corrosion resistance, and strong adaptability to fluctuations in feed volume or density, Granularity, and grade. 2、 Operating principle. The same mortar is slowly fed onto the spiral groove surface through a feeding groove installed at the head end of the rotating groove for sorting. The tail of the rotating groove is equipped with a valve type product selection groove, which divides the selection equipment into three categories according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows the obtained multi head ore flow to be differentiated, merged and exported. The cross section of the spiral concentrator and the slope change of the curve are particularly suitable for the selection of fine particle materials. spiral chute CAD drawings, three advantages: 1. Stable, easy to operate, and a large density range. 2. The material processing has a large production capacity, high concentration, and high recovery rate. 3. Small space occupation, low water consumption, simple structure, and no need for power. 4. Easy installation, easy operation, low investment, and fast efficiency. Spiral chute CAD drawing 4. The structure constitutes a coking spiral chute. The spiral chute CAD drawing consists of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product acquisition chute, an equipment gathering hopper, and a groove support (including a cross or triangular frame). The spiral groove formed by connecting the spiral pieces is a key component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together by screws. The selection surface of the rotating groove has a pre made wear-resistant layer. She has the advantages of lightweight, sturdy, and durable consumer goods that are not easily damaged. The head of the spiral groove is equipped with a multi tube feeding homogenizer to sort minerals evenly, which is not cumbersome to operate. The mineral sorting device is freely placed on the cross (or tripod) of the support table. The evenly divided mortar is slowly fed onto the surface of the spiral groove through the feeding chute at the head end of the rotating groove for sorting. The tail of the rotating groove is installed in a valve block type new product selection groove, allowing the selection of new equipment to be divided into three (or four) types of new products radially according to grade. Change the cutting width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that distinguishes and converges the obtained multi head ore flows. The horizontal plane of the spiral concentrator is particularly suitable for the separation of small particle ore materials when the slope of the curve changes. 5、 Application. The scope of application of this machine is to separate iron ore, ferrotitanium ore, ferrochrome, ferrosulfide, zircon ore, Rutile, monazite, phosphate ore, tungsten ore, placer tin, tantalum, niobium ore and other non-ferrous metals, rare mineral metals and non nonferrous metal mineral bodies with gravity difference from fine materials with Granularity of 0.3-0.02MM. Spiral Chute CAD Drawing Spiral Chute CAD Drawing