Spiral chute tool

Spiral chute tool 1: Introduction: Gravity separation is widely used in the beneficiation of metallic and non-metallic ores due to its low environmental pollution and low cost. Glass fiber reinforced plastic chute is one of the gravity beneficiation equipment, with a structural feature of a cubic parabolic cross-section. It is suitable for processing finer particle sizes of -0.2mm. In the sorting step, there is no need to add water to wash, and the bottom of the chute is divided into sections to obtain refined, medium, and tailings. 2、 Technical principle: The spiral chute separator is not limited to being placed on the cross (or tripod) of the support table. Equal slurry is slowly fed to the spiral groove surface through the feeding chute at the end of the rotating groove head for sorting. The bottom is equipped with a valve block type equipment acquisition slot, allowing other products to be divided into three types (or four types) according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that collects and exports the intercepted variable mineral flows separately. The transverse surface of the fiberglass chute has a very variable slope, which is suitable for the selection of fine particle materials. Spiral Chute Tool III. Advantages and Features: 1. Ultra high efficiency, high recycling rate, and precise mineral sorting; 2. Do not use power; 3. Lightweight, rust resistant, wear-resistant, and not easily corroded; 4. Low operating costs and long application life; Strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade; The friction caused by the surface of 6 diamond sand makes the beneficiation effect better than other plastic surfaces. Spiral Chute Tool 4. Structural Composition: The fiberglass chute is composed of six parts: a feeding homogenizer, a feeding groove, a rotating groove, an equipment selection groove, a product gathering hopper, or a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting spiral pieces is a key accessory. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue), connected together by screws, and the rotating groove has a pre designed durable wear-resistant layer on the selected surface. It also has the advantages of light weight, durability, and durability in using consumer goods. Above the spiral groove is a multi tube feeding homogenizer that screens ore evenly, making it easy and convenient to operate. The sorting machine is not limited to being placed on the cross (or tripod) of the support table. The uniform mortar is slowly fed onto the spiral groove surface by installing the feeding groove at the head end of the rotating groove for sorting. The tail of the rotating groove is equipped with a valve type new equipment to cut the groove and classify the selected new products into three categories (or four categories) radially according to grade. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the selected multi head ore flows to converge and lead out separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the selection of fine-grained ore. 5、 This equipment is suitable for separating iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphate rock, tungsten ore, tin ore, tantalum ore, niobium, and other non-ferrous metals, rare mineral metals and non colored metal minerals obtained by gravity difference from fine materials with Granularity of 0.3-0.02mm. Spiral Chute Tool Spiral Chute Tool