Installation of spiral chute

Spiral chute installation 1. Introduction: Gravity beneficiation is widely used in metal and non-metallic ore beneficiation due to its small environmental pollution and low cost. The fiberglass chute is one of the gravity separation equipment, with a structural feature of a cubic parabolic cross-section, suitable for handling finer particle sizes of -0.2mm. During the sorting step, there is no need to add flushing water, and the fine, medium, and tailings are segmented at the bottom of the chute. 2、 Using a method to set up a spiral concentrator, align it with the vertical line, use an iron frame or wood to fix it in a suitable position, and use a sand pump to transport the ore to the two feeding ports on the spiral head. Add supplementary water, adjust the concentration of the ore slurry, and the ore slurry will naturally swirl from top to bottom. In the flow rate of the inclined plane of the rotation, an inertial centrifugal force will occur, which will cause differences in the gravity, particle size, and shape of the sand ore, Through the influence of the gravity or centrifugal force of the swirling flow, the sand ore is separated, and the selected ore flows into the concentrate hopper and is piped out. The tailings flow into the tailings hopper and are piped to the sand ore pool, and then discharged by a slurry pump, completing the entire beneficiation process. Installation of the spiral chute: III. Highlights and characteristics: 1. Stable, easy to control, and with a relatively large concentration range. 2. The material production and processing capacity is large, with a high enrichment ratio and a high probability of recovery. 3. The area is not occupied much, consumes less water, has a simple structure, and does not require power. 4. Easy installation, simple operation, low investment, and quick returns. Spiral chute installation IV. According to the Granularity of ore processed, the chutes can be divided into three categories: (1) Coarse size chutes. The maximum Granularity of feeding is more than 2-3 mm, and the maximum can reach 100-200 mm. (2) The ore chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, with a feeding particle size less than 0.074MM. 5、 Scope of application: FRP spiral chute is suitable for separating fine grained iron ore, ferrotitanium ore, chromite ore, pyrite, cassiterite, tantalum niobium ore, gold ore, coal, monazite ore, Rutile ore, zircon sand, rare earth ore and other metal and non-metallic mineral materials with sufficient specific gravity difference. Installation of spiral chute Installation of spiral chute