Can the spiral chute be used

Can spiral chutes be used? Firstly, introduce the semi open spiral chutes. Can spiral chutes be used to separate minerals under the inclined flow separation step. Mineral mortar is provided on a partially inclined chute or inclined surface. With the assistance of water, the mineral particle group is not tightened and layered. The lighter mineral material on the upper part is quickly discharged to the outside of the chute, while the heavier mineral material on the lower part stays in the inner groove or flows out at a slow speed from the lower part. After being obtained separately, concentrate and tailings are obtained. The fiberglass spiral chute is an equipment for mining and beneficiation, making it ideal for mining sand mines in coastal areas, riverbanks, sandbanks, and streams. The product also has the characteristics of reasonable structure, simple installation, less land occupation, simple operability, stable beneficiation, clear screening of ore, large processing output, high efficiency, high beneficiation concentration ratio, high recovery rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to feed volume, density, Granularity, and grade fluctuation. 2、 Production principles. The spiral concentrator is freely placed on the cross (or tripod) of the support table. The evenly proportioned mortar is slowly fed onto the surface of the spiral groove through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The tail end is equipped with a valve block type equipment cutting groove, which divides the sorted products into three (or four) categories according to grade along the radial direction. Change the acquisition width of each product by adjusting the position of the valve block. The equipment gathering bucket is a concentric circular tube that allows the selected variable ore flows to converge and export differently. The cross section and slope of the curve of the fiberglass chute are very suitable for the separation of small particle materials. Can the spiral chute of be used with three characteristics. The spiral chute has attracted more attention among various gravity separation machines due to its low power consumption, simple structure, small land occupation, simple operation, stable beneficiation, clear ore separation, no moving parts, convenient Computerized maintenance management system, large single area processing capacity, etc. The machine has a wide or gentle groove surface, and the area where the mortar flows in laminar flow is large, which is more suitable for processing medium and fine (-4MM) Granularity ores. Spiral concentrators with diameters of 400, 600, 900, and 1200mm have been produced domestically, Ф The production capacity of 1200mm four heads is about 4-6 T/H. Can the spiral chute be composed of a structure of . Can the spiral chute be used? The spiral concentrator consists of a feeding device, a cross (tripod), a feeding chute, a spiral groove, a cutting groove, a gathering bucket, and a groove support. 5、 Purpose. Can the spiral chute be used to separate 0.3-0.02mm fine materials into iron ore, ilmenite, chromite, pyrite, zircon sand, Rutile, monazite, phosphoethylene, tungsten ore, placer tin, tantalum, niobium ore or other non-ferrous metal ores, rare metals and non-metallic ore bodies with different density and specific gravity. Can the spiral chute be used? @ @ 000 Can the spiral chute be used