Spiral chute of mixing drum

Mixing drum spiral chute 1. Product introduction: Can the spiral chute be used? The mixing drum spiral chute is a gravity beneficiation equipment that utilizes the inertial centrifugal force that occurs during the spiral rotation movement of mineral slurry to separate light and heavy mineral materials. 2、 The working principle is that the same mortar as the spiral chute of the mixing drum is slowly fed to the surface of the spiral groove through the feeding groove installed at the end of the rotating groove head, and sorting is carried out. The tail end of the rotating groove is equipped with a valve block type product cutting groove, allowing the selected equipment to be divided into three types according to grade along the radial direction. By adjusting the position of the valve block to change the selection width of each product, the equipment gathering hopper will collect and export the obtained multi head ore flow. The transverse plane of the spiral chute and the different slopes of the curves are particularly suitable for the separation of small particles of mineral materials. Mixing drum spiral chute III. Advantages and characteristics: 1. High efficiency, high recovery rate, and precise ore separation; 2. No power required; 3. Lightweight, rust resistant, durable, wear-resistant, and corrosion-resistant; 900 spiral chute installation video, 4 low cost, long application life; Strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade; The frictional force on the surface of 6 diamond sand makes the beneficiation effect better than other plastic surfaces. Mixing drum spiral chute . 4、 The structure of the spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product intercepting chute, an equipment gathering hopper, and a bracket for this chute (including a cross or triangular frame). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced with coal gangue) and connected together by bolts. The sorting surface of the rotating groove has a pre made wear-resistant layer. It has the advantages of lightweight, sturdy, and long-lasting consumer goods that are not easily damaged. The spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is easy to operate. There is no need to restrict the stacking of mineral sievers on the cross (or tripod) of the support table. The evenly distributed mineral mortar is slowly fed to the surface of the spiral groove through the feeding groove at the beginning of the rotating groove, and then selected for operation. The bottom of the rotating groove is equipped with a valve block type new product selection groove, which allows the sorting equipment to be divided into three categories (or four types) of new products according to grade along the radial direction. Change the acquisition width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that collects and exports the intercepted variable mineral flows. The cross section and slope of the curve of the fiberglass chute are very suitable for the selection of fine particle materials. 5、 Utilize the field. The spiral chute of the mixing drum is suitable for processing 0.6-0.03MM and vein ores as well as minerals, but it is unfavorable for sorting when the mud content is high. It is now widely used for processing iron ore, tungsten, sand tin, tantalum niobium ore, bay and riverbed ore sand or placer gold, and so on. Mixing drum spiral chute Mixing drum spiral chute