Spiral chute desulfurization

Spiral chute desulfurization 1. Introduce the process of chute beneficiation, including inclined flow separation. The slurry is fed to a inclined groove or inclined surface, and with the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The lighter minerals in the upper layer are quickly discharged to the outside of the groove, while the heavy ore materials in the lower part stagnate in the inner groove or flow out at a slow speed from the lower part. After being collected separately, the concentrate and tailings can be obtained. Glass fiber reinforced plastic chutes are machinery for mining and beneficiation, especially ideal for sand mining and beneficiation in bays, riverbanks, sandbanks, and streams. The product has the characteristics of reasonable structure, simple installation, small footprint, simple operation, stable beneficiation, clear separation of ore, large processing output, high efficiency, high beneficiation enrichment ratio, high recovery rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to fluctuations in feed volume, density, Granularity, and grade. 2、 The technical principle is that the mineral mortar is slowly fed onto the rotating groove surface through a feeding groove installed at the head of the spiral groove for sorting. The tail of the spiral groove is equipped with a valve type product selection groove, which divides the selection equipment into three categories according to grade along the radial direction. By adjusting the orientation of the valve block to change the cutting width of each product, the equipment gathering hopper enables the multi-directional mineral flow to be differentiated and converged. The transverse surface of the fiberglass chute and the slope change of the curve are particularly suitable for the selection of fine particle materials. spiral chute desulfurization III. Advantages and characteristics: 1. High efficiency, high recovery rate, and correct mineral sorting; 2. No power required; 3. Small weight, rust proof, wear-resistant, and not easily corroded; 4. Low operating cost and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction formed by the surface of 6 diamond sand makes the beneficiation efficiency better than that of other plastic surfaces. The spiral chute desulfurization system consists of six parts: a feeding homogenizer, a feeding chute, a spiral groove, an equipment selection groove, a product gathering hopper, and a groove bracket (including a cross or triangular frame). The rotating groove connected by spiral blades is a key component. The rotating plate is made of fiberglass (fiber reinforced coal gangue), connected together by screws, and the spiral groove has a pre made wear-resistant layer on the selected surface. She has the advantages of being lightweight, sturdy, and durable consumables that are not easily damaged. Above the rotating groove, there is a multi tube feeding homogenizer for ore separation, which is simple and convenient to control. The sieving mineral containers are freely stacked on the cross (or tripod) of the support table. The evenly distributed mortar is slowly fed onto the surface of the rotating groove through the feeding groove installed at the head of the spiral groove, and sorting is carried out. The tail end of the spiral groove is equipped with a valve block type new equipment to obtain the groove. The selected new products are divided into three categories (or four types) according to grade along the radial direction. Change the cutting width of each new equipment by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the selected multiple ore streams to converge and lead out separately. The slope change of the cross-section and curve of the spiral concentrator is very suitable for the separation of fine particle materials. 5、 This equipment is suitable for separating iron ore, Ilmenite, Chromite, pyrite, zircon, Rutile, monazite, phosphoethylene, tungsten, tin ore, tantalum ore, tantalum niobium ore or other nonferrous metals, rare metals and nonferrous metal ore bodies with different density and specific gravity from fine and small materials with Granularity of 0.3-0.02mm. Spiral chute desulfurization Spiral chute desulfurization