Rutile spiral chute

The spiral chute of Rutile ore 1. Introduce the dressing chute, including the inclined flow separation process. Mineral mortar is applied to a partially inclined chute or inclined surface. With the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The upper part of the light mineral material quickly flows out of the groove, while the lower part of the heavy mineral material stagnates in the inner groove or slowly flows out from the lower part. After distinguishing and connecting, the concentrate and tailings can be obtained. Spiral chutes are machinery for mining and beneficiation, especially ideal for sand mining in coastal areas, riverbanks, sandbanks, and streams. The product also has the characteristics of reasonable structure, simple installation, small land occupation, simple operation, stable beneficiation, clear screening of ore, large production capacity, high efficiency, high beneficiation enrichment ratio, high recovery probability, and stable operation. It has the advantages of light weight, moisture prevention, rust prevention, strong corrosion resistance, and strong applicability to feed volume and density, Granularity, and grade fluctuation. 2、 The use method is to erect the glass fiber reinforced plastic spiral chute, calibrate the vertical line, fix it in an appropriate position with an iron frame or wood, send the ore sand to the two ore feeding ports above the spiral by the sand pump, mix in the make-up water, and adjust the concentration of the ore slurry. The ore slurry naturally swirls from high to low, generating a single coherent centrifugal force in the flow speed of the revolving inclined surface, so as to obtain the difference in the specific gravity, Granularity and state of the placer, Through the effect of gravity and centrifugal force obtained through swirling flow, the sand ore is separated, and the concentrate flows into the beneficiation hopper and is connected out through pipelines. The tailings are discharged into the tailings hopper and connected to the sand pit through pipelines, and then discharged by a slurry pump, completing the entire beneficiation process. Rutile spiral chute 3. Advantages 1. Stable, easy to control, with a large density range. 2. High material processing yield, high enrichment ratio, and high recycling rate. 3. Small footprint, low water consumption, simple structure, and no need for power. 4. Simple installation, simple operation, low investment, and fast returns. Rutile spiral chute IV. The structure of the spiral chute is composed of six parts: ore feeder, ore feeder, rotary chute, product obtaining chute, equipment gathering hopper, and this chute bracket (including cross or tripod). The spiral groove connected by the rotating disc is a key component. The spiral plate is made of fiberglass (fiber reinforced coal gangue), and a wear-resistant layer is pre made on the sorting surface of the rotating groove through bolts. She has the advantages of lightweight, strong, and durable consumer goods. Above the spiral groove, a multi tube feeding homogenizer is installed to evenly distribute the ore, and the operation is not complicated. The screening machine is not limited to being placed on the cross (or tripod) of the support table. The evenly distributed slurry is slowly fed onto the spiral groove surface through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The tail end of the rotating groove is equipped with a valve block type new equipment to intercept the groove, allowing the sorted new products to be divided into three categories (or four categories) according to grade along the radial direction. Change the selection width of each new equipment by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that gathers and exports various obtained mineral flows. The lateral plane of the spiral concentrator and the slope change of the curve are extremely suitable for the selection of fine-grained materials. 5、 Applicable field: The fiberglass chute is suitable for processing 0.6-0.03mm and vein ore as well as sand ore, but it is unfavorable for sorting when the mud content is high. Nowadays, it has been widely used in the processing of iron ore, tungsten, tin, tantalum niobium ore, coastal and riverside ore sands, gold mines, and so on. Rutile spiral chute Rutile spiral chute