current location: home > News and information > Reselection of knowledge
update date:2023-07-16 03:13:36Number of views: author:huang
Spiral chute ll1200 parameter power pitch 360 spiral chute, spiral chute ll1200 parameter power 1. Introduction: Gravity separation is widely used in the beneficiation of metal or non-ferrous metal mines due to its low environmental pollution and low cost. The spiral beneficiation machine is one of the gravity beneficiation equipment, characterized by a cubic parabola shaped cross-section, suitable for processing finer particle sizes of -0.2 millimeters. In the beneficiation process, there is no need to add flushing water, and the fine, medium, and tailings are segmented at the tail end of the tank. 2、 The spiral chute shall be used for large and small purposes. The spiral chute shall be erected, the vertical line shall be calibrated, and the iron frame or wood shall be fixed at the proper position. The mineral sand shall be sent to the two ore feeding ports above the spiral by the mortar pump to participate in water filling and adjust the density of the mineral sand slurry. The mineral slurry will naturally swirl from top to bottom. A single coherent centrifugal force will be generated in the flow speed of the rotating slope. The difference will be based on the specific gravity, Granularity and state of the placer, By separating the ore and sand through the gravity of the swirling flow and the effect of this centrifugal force, the selected ore flows into the concentrate hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand tank through a pipeline, and then discharged by a slurry pump, completing the entire beneficiation process. Spiral Chute ll1200 Parameter Power III. Advantages and Features: 1. High efficiency, high recovery rate, correct screening of minerals; 2. Do not use power; 3. Lightweight, rust resistant, wear-resistant, and corrosion-resistant; 4. Low operating costs and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The frictional force formed on the surface of 6 diamond sand makes the beneficiation efficiency better than that of other plastic surfaces. Spiral chute ll1200 parameter power . 4、 The structural composition of the spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a rotating chute, an equipment selection chute, a product gathering hopper, and a support bracket (including a cross or triangular frame). The spiral groove formed by connecting rotating discs is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue), and a wear-resistant layer is pre made on the sorting surface of the rotating groove through bolts. It also has the advantages of lightweight, sturdy, and long-lasting consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is easy to operate. The mineral sorting device is freely placed on the cross (or tripod) of the support table. The evenly divided mineral mortar is slowly fed onto the spiral groove surface through the feeding groove installed at the beginning of the rotating groove for selection. The bottom of the rotating groove is equipped with a valve block type new product acquisition groove, which allows the sorted new products to be divided into three categories (or four categories) of new equipment along the radial direction according to grade. Change the cutting width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that gathers and exports the selected variable mineral flows. The cross section and slope of the curve of the fiberglass chute are particularly suitable for the selection of fine particle materials. 5、 Suitable for manufacturers of experimental spiral chutes. This equipment is suitable for separating iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphorus ethyl, tungsten, sand tin, tantalum niobium, tantalum niobium of fine materials with a particle size of 0.3-0.02mm, and has the specific gravity difference to obtain other non-ferrous metal ores, rare metals and this non-metallic orebody. Spiral chute ll1200 parameter power Spiral chute ll1200 parameter power
Spiral chute ll1200 parameter power