Spiral chute control

Spiral Chute Control 1. Equipment Introduction. A gravity beneficiation machine used for the separation of light and heavy minerals by the coherent centrifugal force that occurs in the rotary spiral motion of mortar. 2、 Use skills to make the spiral concentrator stand up, align it with the vertical line, use an iron shelf or wood to stabilize it in a suitable position, use the sand pump to transport the ore sand to the two feeding ports on the spiral head, add make-up water, and adjust the concentration of the ore slurry. The mineral slurry naturally swirls from high to low, and an inertial centrifugal force occurs in the flow rate of the swirling inclined surface to obtain the difference in gravity, Granularity and shape of the sand ore, By achieving the efficiency of gravity or centrifugal force through swirling flow, the ore and sand are separated, and the concentrate is discharged into the beneficiation hopper and connected out through pipelines. The tailings flow into the tailings hopper and are connected to the sand pit through pipelines, and then discharged by a mortar pump, completing the entire beneficiation process. Spiral chute control 3. Characteristics 1. Stable sorting steps and easy control 2. Large allowable range of feed density 3. Very high enrichment ratio and high recovery probability 4. Small area occupied and low water consumption 5. Simple structure, no power for spiral chute in Jiangxi laboratory, spiral chute control 6. Strong processing capacity 7. Simple installation and operation 8. Small investment, quick effect spiral chute control 4 The construction constitutes a spiral chute for customer use on-site. The fiberglass spiral chute consists of six parts: a feeding distributor, a feeding trough, a spiral trough, an equipment selection trough, a product gathering hopper, and a trough bracket (including a cross or triangular frame). The rotating groove formed by connecting rotating pieces is a key component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together through screws. The sorting surface of the spiral groove has a pre designed durable and wear-resistant layer. He also has the advantages of lightweight, sturdy, and durable consumables. A multi tube ore feeding homogenizer is installed above the rotating groove to screen minerals, which is also easy to operate. The screening machine is freely placed on the cross (or tripod) of the support table. The uniform mineral mortar is slowly fed onto the rotating groove surface through the feeding groove on the spiral groove head for selection. The bottom of the spiral groove is installed in a valve block type new equipment cutting groove, and the sorted new products are divided into three (or four) types of new products along the radial direction according to grade. Change the selected width of each new equipment by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the obtained multi head ore flow to be gathered and exported separately. The change in the slope of the cross-section and curve of the fiberglass chute is particularly applicable for the selection of fine-grained mineral materials. 5、 Applicable. This equipment is suitable for separating iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphorus, ethylene, tungsten, sand tin, tantalum niobium, tantalum niobium of fine materials with a particle size of 0.3-0.02mm, and has the specific gravity difference to obtain other nonferrous metal ores, rare metals and this non-metallic orebody. Spiral chute control Spiral chute control