Problems in the Application of Spiral Chutes

Problems in the Application of Spiral Chutes

Introduction to the problems in the application of spiral chutes. The separation of minerals by the chute belongs to the inclined flow separation process. The slurry is fed to a inclined chute or inclined surface, and under the push of water flow, the ore particles are loose and layered. The light minerals in the upper layer are quickly discharged from the groove, while the heavy mineral materials in the lower layer stay inside the groove or slowly discharge from the lower part. After being connected separately, concentrate and tailings can be obtained. Glass fiber reinforced plastic chutes are machines for mining and beneficiation, especially ideal for sand mining in coastal areas, riverbanks, sandbanks, and river beds. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear beneficiation, strong processing ability, high efficiency, high concentration of beneficiation, high recycling rate, and reliable operation. It has the advantages of lightweight, moisture-proof, rust prevention, corrosion resistance, and strong adaptability to fluctuations in feed volume, concentration, particle size, and grade. 2、 Technical principles, problems in the application of spiral chutes, and the use of fiberglass spiral chutes for mineral sorting are not limited to stacking on crosses (or tripods) on support tables. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed at the end of the rotating groove head for sorting. The tail is equipped with a valve type product selection slot, which divides the selection equipment into three types (or four types) according to grade along the radial direction. Change the cutting width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that allows the obtained multi head ore flow to gather and lead out. The cross section of the spiral chute is particularly suitable for the selection of fine ore particles due to changes in the slope of the curve. The problems in the application of the central cylindrical spiral chute are as follows: 1. The selection process is stable and easy to control, The fourth problem in the application of spiral chutes is the construction of a spiral chute. The spiral chute consists of six parts: a feed distributor, a feed chute, a rotating chute, a product intercepting chute, an equipment gathering hopper, and a support bracket (including a cross or triangular frame). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced with coal gangue) and connected together by bolts. The sorting surface of the rotating groove has a pre made wear-resistant layer. It has the advantages of lightweight, sturdy, and long-lasting consumer goods that are not easily damaged. The spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is easy to operate. There is no need to restrict the stacking of mineral sievers on the cross (or tripod) of the support table. The evenly distributed mineral mortar is slowly fed to the surface of the spiral groove through the feeding groove at the beginning of the rotating groove, and then selected for operation. The bottom of the rotating groove is equipped with a valve block type new product selection groove, which allows the sorting equipment to be divided into three categories (or four types) of new products according to grade along the radial direction. Change the acquisition width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that collects and exports the intercepted variable mineral flows. The cross section and slope of the curve of the fiberglass chute are very suitable for the selection of fine particle materials. 5、 Purpose. This machine is suitable for separating small materials with a particle size of 0.3-0.02mm to obtain iron ore, ilmenite, Chromite, pyrite, zircon, Rutile, monazite, phosphorus, tungsten ore, tin ore, tantalum niobium ore, tantalum niobium ore and other non-ferrous metal ores, rare ore metals and non-metallic mineral bodies with gravity differences. Problems in the Application of Spiral Chutes Problems in the Application of Spiral Chutes

Problems in the Application of Spiral Chutes