Spiral chute section

Spiral chute section 1 describes that gravity separation is widely used in the beneficiation of metal and non-ferrous metals due to its low pollution and low cost. The fiberglass spiral chute is one of the gravity beneficiation machinery, with a structural feature of a cubic parabolic cross-section. It is used to handle finer particle sizes of -0.2mm, and does not require flushing water in the sorting process. The tail part of the chute is selected in sections to select fine, medium, and tailings. 2、 Operating principle: The spiral chute concentrator does not need to be restricted from being placed on the cross (or tripod) on the support table. The same mineral mortar is slowly fed onto the surface of the rotating groove through the feeding chute at the end of the installation spiral groove head, and selected for operation. The bottom is equipped with a valve block type equipment to obtain slots, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that collects and leads the intercepted multi head ore flow separately. The cross-section of the fiberglass chute and the change in slope of the curve are very suitable for the sorting of fine-grained materials. Spiral chute section 3. Characteristics This product is suitable for separating iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon ore, Rutile, monazite, phosphorus ethyl, tungsten ore, sand tin, tantalum, niobium ore and other non-ferrous metal, rare metal and non-metallic ore bodies with density and specific gravity difference of 0.3-0.02MM fine materials. This equipment also has advantages such as stable and easy operation in the selection process, a wide range of allowable changes in feed density, high enrichment ratio, high recovery rate, small footprint, low water consumption, simple structure, no need for power, strong processing ability, easy installation and operation, low investment, and quick effectiveness. Cross section of spiral chute IV. According to the particle size of processed mineral materials, the chute can be divided into three types: (1) coarse spiral chute. The maximum Granularity of feeding material is more than 2-3mm, and the maximum can be 100-200mm. (2) Mineral sand chute, processing 2-3MM particle grade mineral aggregate. (3) The spiral chute of the ore slurry has a feeding particle size of less than 0.074 millimeters. 5、 Use This machine is suitable for sorting iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon ore, Rutile, monazite, phosphate ore, tungsten ore, tin, tantalum niobium, niobium with a particle size of 0.3-0.02mm and other non-ferrous metal ores, rare metals and non-metallic ore bodies with different density and specific gravity. Spiral chute section Spiral chute section