Where is the spiral chute

Where is the spiral chute? 1. Introduction: The chute beneficiation belongs to the slope flow beneficiation process. Mortar is fed to some inclined grooves or slopes, and under the push of water flow, the mineral particle group becomes loose and layered. The upper layer of light minerals quickly flows out of the groove, while the lower layer of minerals with high specific gravity remain inside the groove or are discharged from the bottom at a low speed. After separation and collection, selected minerals and tailings can be obtained. The spiral concentrator is a machine for mining and beneficiation, making it ideal for mining ore in bays, river beds, sand banks, and streams. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear separation, large processing volume, high efficiency, high beneficiation enrichment ratio, high recycling rate, and reliable operation. It has the advantages of light weight, moisture resistance, rust prevention, corrosion resistance, and strong adaptability to fluctuations in feed volume, concentration, particle size, and grade. 2、 The production principle is that the slurry is evenly distributed and slowly fed onto the surface of the spiral groove through the feeding chute installed on the rotating groove head, implementing sorting. The bottom of the rotating groove is equipped with a valve block type product selection groove, which divides the selection equipment into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows for the differentiation and aggregation of the obtained variable mineral flow. The cross-section of the spiral chute and the slope change of the curve are very suitable for the selection of fine particle materials. Where are the spiral chutes at ? 3. Highlights or characteristics: 1. Ultra high efficiency, high recovery rate, and accurate mineral sorting; 2. No power required; 3. Lightweight, rust resistant, wear-resistant, and corrosion-resistant; 4. Low cost, long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction force formed by the appearance of 6 diamond sand makes the beneficiation efficiency superior to other plastic surfaces. Where is the spiral chute ? 4. According to the particle size of the processed ore, the chute can be divided into three categories: (1) coarse spiral chute. The maximum Granularity of ore feeding is above 2-3MM, and the maximum can reach 100-200mm. (2) The sand ore chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, feeding particle size less than 0.074 millimeters. 5、 The fiberglass spiral chute is suitable for processing 0.6-0.03mm and vein ore as well as sand ore, but it is unfavorable for sorting when the mud content is high. Nowadays, it has been widely used for processing iron ore, tungsten, tin ore, tantalum niobium ore, coastal and riverbed ore, or gold ore. Where is the spiral chute Where is the spiral chute