Where is the spiral chute produced well

Where is the spiral chute produced well

Where is the good production of spiral chutes? Where is the good production of spiral chutes? 1. Introduction: Gravity separation is widely used in metal and non-metallic ore beneficiation due to its low environmental pollution and low cost. The spiral beneficiation machine is one of the gravity beneficiation machines, with a cross-sectional shape of cubic parabola, suitable for processing finer particle sizes of -0.2mm. During the sorting process, do not add flushing water, and cut off the fine, medium, and tailings in sections at the bottom of the tank. 2、 Use skills to set up the FRP spiral chute, calibrate the vertical line, use an iron frame or wood to set the proper position, send the mineral sand to the two ore inlets above the spiral by the sand pump, add makeup water, and adjust the density of the mineral mortar. The mineral slurry naturally swirls from high to low, and a continuous centrifugal force occurs in the flow speed of the swirling inclined surface to obtain the difference in gravity, Granularity and shape of the mineral sand, By achieving the effects of gravity and centrifugal force through swirling flow, the ore is separated, and the selected ore is discharged into the concentrate hopper and connected out through pipelines. The tailings are discharged into the tailings hopper and connected to the sand tank through pipelines, and then discharged by a mortar pump, completing the entire beneficiation process. Where are the good three highlights of the production of the spiral chute? 1. Stable, easy to control, and with a large concentration range. 2. Strong production and processing capacity of mineral materials, high enrichment ratio, and high recovery probability. 3. The area is not occupied much, with low water consumption, simple structure, and no need for power. 4. Installation is simple and easy to operate, with low investment and fast returns. Where are the spiral chutes produced? The spiral concentrator is composed of six parts: a feeding homogenizer, a feeding chute, a spiral groove, an equipment cutting groove, a product gathering hopper or groove support (including a cross or triangular frame), and so on. The main component is the rotating groove connected by the rotating disc. The spiral plate is made of fiberglass (fiber reinforced coal gangue) and is bolted together. The sorting surface of the spiral groove has a pre made wear-resistant layer. She has the advantages of lightweight, sturdy, and durable consumables. A multi tube feeding homogenizer is installed above the rotating groove to evenly sort minerals, making control simple and convenient. The mineral screening device is not limited to being placed on a cross (or tripod) on a supporting table. Uniform mineral mortar is slowly fed to the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and selection is carried out. The tail end of the spiral groove is equipped with a valve block type new equipment to obtain the groove. The sorted new products are divided into three (or four) types of new products along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new equipment gathering bucket is a concentric circular tube that allows the intercepted and variable mineral flows to be densely drawn out. The transverse section of the fiberglass chute and the slope change of the curve are extremely suitable for the selection of fine particle materials. 5、 Use This product is used to separate fine materials with a particle size of 0.3-0.02mm to obtain iron ore, ilmenite ore, chromite ore, pyrite ore, zircon sand, Rutile ore, monazite ore, phosphorus ethylene, tungsten ore, placer tin, tantalum, niobium ore or other non-ferrous metal ores, rare metals and non-metallic ore bodies with different density and specific gravity. Where is the best production method for the spiral chute

Where is the spiral chute produced well